A fully moulded BNC to BNC Cable (1 m).

A moulded BNC to BNC Cable (2 m).

Use with Tendon Hammer and any transducer with a BNC connector where an extended cable is required.

A BNC to BNC Cable (6 m long).

Used with multichannel Bridge or Bio Amps including the Quad Bridge Amp, Octal Bridge Amp, Octal Bio Amp, or any other device with multiple BNC connections.

The cable has four colored sheaths, black, red, blue and  yellow, to enable easy identification of cable connections.

Allows connection of devices with the corresponding stereo output connector to any BNC input of a PowerLab.

Used to connect a Grass Amplifier Analog Output or a Finapres Nova Analog Output to a PowerLab.

Used to connect audio Headphones to a PowerLab Output.

Can be used with the PowerLab and LabChart in conducting audio evoked experiments in the student classroom.

Used to connect the Thermocouple to Analog Converter to a PowerLab.

Used to connect the Millar Pressure Signal Conditioner to the PowerLab inputs.

Connects to any BNC plug, allowing any signal to be split between two devices.

A set of two BNC to Alligator Clips (differential).

Used with the Thermocouple/Analog Converter.

Required for use with Inputs 3 and 4 on the PowerLab 26T to allow the connection and operation of any front-ends or other external devices with BNC connectors. Can also be used to connect a transducer with a BNC connector to Inputs 1 and 2.

Supplied with the following:

(2) in PowerLab 26T (LTS)
(1) in Galvanic Oxygen Electrode